60
KENR6932
Disassembly and Assembly Section
Disassembly Procedure (Engine Oil
Cooler with a Low Mounted Filter
Base)
g01336430
Illustration 101
Typical example
1.
Remove bolts (15).
2.
Remove cooler matrix (19) from spacer plate (17).
3.
Remove joint (18).
i02654365
Engine Oil Cooler - Remove
(Engine Oil Cooler with a High
Mounted Filter Base)
Removal Procedure
Start By:
a.
Remove the bracket for the Electronic Control
Module. Refer to Disassembly and Assembly,
“ECM Mounting Bracket - Remove and Install”.
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, “Gen-
eral Hazard Information and High Pressure Fuel
Lines” for safety information.
Refer to System Operation, Testing and Adjusting,
“Cleanliness of Fuel System Components” for de-
tailed information on the standards of cleanliness
that must be observed during ALL work on the fu-
el system.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that
fl
uids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the
fl
uid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing
fl
uids.
Dispose of all
fl
uids according to local regulations and
mandates.
1.
Drain the coolant from the cooling system into
a suitable container. Refer to Operation and
Maintenance Manual, “Cooling System Coolant -
Change” for the correct procedure.
2.
Place a suitable container below the engine oil
cooler in order to catch any
fl
uids that might be
spilled.