Perkins 1106C Series, Disassembly And Assembly, Page: 102 / 192

102 KENR6932
Disassembly and Assembly Section
g01339557
Illustration 196
1. Remove Allen head screw (1) from accessory
drive housing (8). Remove Allen head screws (6)
from accessory drive housing (8).
2. Remove accessory drive housing (8) from the
front housing.
3. If necessary, follow Steps 3.a through 3.c in order
to disassemble the accessory drive.
a. Remove circlip (2) from accessory drive
housing (8).
b. Place accessory drive housing (8) onto a
suitable support. Press the assembly of gear
(4) and bearings (3) and (5) out of accessory
drive housing (8). Use a suitable puller in order
to remove bearings (3) and (5) from gear (4).
c. Remove O-ring seal (7) from accessory drive
housing (8).
Installation Procedure
Table 45
Required Tools
Tool
Part
Number
Part Description Qty
A
21820603
POWERPART Retainer
-
B
21820221
POWERPART
Rubber Grease
1
C
21820117 3 Bond 1386D 1
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01339559
Illustration 197
1. If necessary, follow Steps 1.a through 1.e in order
to assemble the accessory drive.
a. Inspect the condition of the teeth and the
splines of gear (4) for wear or damage. Inspect
bearings (3) and (5), circlip (2), and the front
housing for wear or damage. Replace any
components that are worn or damaged.
b. Apply a small continuous bead of Tooling (A) to
inner surface (X) of bearing (5). Place the gear
shaft on a suitable support. Press on the inner
race of bearing (5) until bearing (5) is against
the shoulder of gear (4). Remove any excess
sealant.
c. Apply a small continuous bead of Tooling (A)
to inner surface (Z) of bearing (3). Place the
front face of the inner race of bearing (3) onto
a suitable support. Press the shaft of gear (4)
into bearing (3) until the shoulder of the gear
is against the bearing. Remove any excess
sealant.