KENR6932
115
Disassembly and Assembly Section
Start By:
a.
Remove the valve mechanism cover. Refer to
Disassembly and Assembly, “Valve Mechanism
Cover - Remove and Install”.
b.
Remove the fuel injection lines. Refer to
Disassembly and Assembly, “Fuel Injection Lines
- Remove”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01342484
Illustration 224
1.
Place a temporary identi
fi
cation mark on
connections (1) for harness assembly (4).
2.
Use a deep socket to remove connections (1)
from electronic unit injectors (2).
3.
If necessary, follow steps 3.a through 3.f in order
to remove harness assemblies (4) from valve
mechanism cover base (7).
a.
Cut cable strap (3).
b.
Disconnect plug (6) from harness assembly (4).
c.
Use Tooling (A) to remove circlip (5).
d.
From the outside of valve mechanism cover
base (7), push harness assembly (4) inward.
Withdraw the harness assembly from valve
mechanism cover base (7).
e.
Remove O-ring seal (8) from harness assembly
(4).
f.
Repeat steps 3.b through 3.e in order to
remove the remaining harness assemblies.
g01342485
Illustration 225
g01342487
Illustration 226
4.
Loosen isolated screws (9) in reverse numerical
order. Refer to illustration 226. This will help
prevent distortion of valve mechanism cover base
(6).
5.
Remove valve mechanism cover base (7) from
the cylinder head.
6.
Remove isolated screws (9) from valve
mechanism cover base (7).
7.
Remove seal (10) from valve mechanism cover
base (7).