50
KENR6932
Disassembly and Assembly Section
5.
Apply Tooling (A) to bolts (5). Install the bolts to
inlet manifold (4).
g01335892
Illustration 88
6.
Tighten the bolts to a torque of 22 N·m (16 lb ft) in
the sequence that is shown in Illustration 88.
7.
Ensure that inlet connection (2) is clean and
free from damage. If necessary, replace the inlet
connection.
8.
Position a new gasket (3) onto the inlet manifold.
Install inlet connection (2) to inlet manifold (4).
9.
Install bolts (1) to inlet connection (2). Tighten the
bolts to a torque of 22 N·m (16 lb ft).
10.
Install the air temperature sensor. Refer
to Disassembly and Assembly, “Inlet Air
Temperature Sensor - Remove and Install”.
11.
Install the boost pressure sensor. Refer to
Disassembly and Assembly, “Boost Pressure
Sensor - Remove and Install”.
12.
Position the harness assembly on the inlet
manifold. Use new cable straps in order to secure
the harness assembly.
13.
Connect the breather hose to the separator for
the crankcase breather (not shown). Refer to
Disassembly and Assembly, “Crankcase Breather
- Install”.
14.
If the engine is equipped with a cover over the
fuel system this will need to be installed.
End By:
a.
Install the ECM mounting bracket. Refer to
Disassembly and Assembly, “ECM Mounting
Bracket - Remove and Install”.
b.
Install the fuel manifold. Refer to Disassembly and
Assembly, “Fuel Manifold - Install”.
c.
If necessary, install the fuel
fi
lter base. Refer to
Disassembly and Assembly, “Fuel Filter Base -
Remove and Install”.
i02654522
Inlet and Exhaust Valve
Springs - Remove and Install
Removal Procedure
Table 16
Required Tools
Tool
Part
Number
Part Description
Qty
A
-
Circlip Pliers
1
21825739
Valve Spring Compressor
1
27610235
Adapter
1
B
27610295
Head
1
C
21825576
Crankshaft Turning Tool
1
27610291
Barring Device Housing
1
C
27610289
Gear
1
Start By:
a.
Remove the rocker shaft assembly. Refer to
Disassembly and Assembly, “Rocker Shaft and
Pushrod - Remove”.
Note:
Either Tooling (A) can be used. Use the Tooling
that is most suitable.