Perkins 1106C Series, Disassembly And Assembly, Page: 122 / 192

122 KENR6932
Disassembly and Assembly Section
d. Remove the fuel manifold. Refer to Disassembly
and Assembly, “Fuel Manifold - Remove and
Install”.
e. Remove the electronic control module and the
mounting bracket. Refer to Disassembly and
Assembly, “Electronic Control Module - Remove
and Install”.
f. Remove the electronic unit injectors. Refer to
Disassembly and Assembly, “Electronic Unit
Injector - Remove”.
g. Remove the valve mechanism cover base. Refer
to Disassembly and Assembly, “Valve Mechanism
Cover Base - Remove”.
h. Remove the glow plugs. Refer to Disassembly
and Assembly, “Glow Plugs - Remove and Install”.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fl uids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fl uid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fl uids.
Dispose of all fl uids according to local regulations and
mandates.
1. Drain the coolant from the cooling system into
a suitable container for storage or for disposal.
Refer to Operation and Maintenance Manual,
“Cooling System Coolant - Change” for the correct
draining procedure.
g01340072
Illustration 241
Typical example
2. Disconnect the upper radiator hose from water
temperature regulator housing (1) on the cylinder
head.
g01340075
Illustration 242
Typical example
3. Remove the air inlet hose from inlet connection
(3) on inlet manifold (2).
4. Follow Steps 4.a and 4.b in order to disconnect
harness assembly (4) from coolant temperature
sensor (5).
a. Slide the locking tab into the unlocked position.
b. Disconnect harness assembly (4) from coolant
temperature sensor (5).
5. Follow Steps 5.a and 5.b in order to disconnect
harness assembly (4) from boost pressure sensor
(6).
a. Slide the locking tab into the unlocked position.
b. Disconnect harness assembly (4) from boost
pressure sensor (6).
6. Follow Steps 6.a and 6.b in order to disconnect
harness assembly (4) from inlet air temperature
sensor (7).
a. Slide the locking tab into the unlocked position.
b. Disconnect harness assembly (4) from inlet air
temperature sensor (7).