KENR6932
165
Disassembly and Assembly Section
•
Ensure that the backs of the bearings and the
bores are clean and dry.
•
Ensure that the bearing locking tabs are properly
seated in the tab grooves.
•
The crankshaft must be free of oil at the contact
points of Tooling (A).
1.
Put a piece of Tooling (A) on the crown of the
bearing that is in the cap.
Note:
Do not allow Tooling (A) to extend over the
edge of the bearing.
2.
Use the correct torque-turn speci
fi
cations in order
to install the bearing cap. Do not use an impact
wrench. Be careful not to dislodge the bearing
when the cap is installed.
Note:
Do not turn the crankshaft when Tooling (A)
is installed.
3.
Carefully remove the cap, but do not remove
Tooling (A). Measure the width of Tooling (A)
while Tooling (A) is in the bearing cap or on the
crankshaft journal. Refer to Illustration 333.
g01152855
Illustration 333
Typical Example
4.
Remove all of Tooling (A) before you install the
bearing cap.
Note:
When Tooling (A) is used, the readings can
sometimes be unclear. For example, all parts of
Tooling (A) are not the same width. Measure the
major width in order to ensure that the parts are
within the speci
fi
cation range. Refer to Speci
fi
cations
Manual, “Connecting Rod Bearing Journal” and
Speci
fi
cations Manual, “Main Bearing Journal” for the
correct clearances.
i02654468
Crankshaft Position Sensor -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
g01341527
Illustration 334
1.
Slide locking tab (1) into the unlocked position.
2.
Disconnect harness assembly (2) from position
sensor (3).
3.
Remove bolt (4).
4.
Carefully remove position sensor (3) from the
cylinder block.
Note:
Do not use a lever to remove the position
sensor from the cylinder block.
5.
Remove O-ring seal (5) from position sensor (3).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.