Perkins 1106C Series, Disassembly And Assembly, Page: 173 / 192

KENR6932 173
Disassembly and Assembly Section
g01341735
Illustration 349
1. Ensure that the threads of the glow plugs are clean
and free from damage. Replace any damaged
glow plugs.
2. Install glow plugs (4) into the cylinder head.
Tighten the glow plugs to a torque of 15 N·m
(132 lb in).
3. Position bus bar (1) onto glow plugs (4). Install
nuts (2) onto the glow plugs. Tighten the nuts to a
torque of 2 N·m (17 lb in).
4. Connect wire (5) to the stud on terminal insulator
(6).
5. Install nut (3) to the stud on terminal insulator (6).
Tighten the nut to a torque of 6 N·m (53 lb in).
6. Connect the breather hose to the crankcase
breather. Refer to Disassembly and Assembly,
“Crankcase Breather - Install”.
7. Restore the electrical supply to the engine.
i02654452
Alternator Belt - Remove and
Install
Removal Procedure
Table 81
Required Tools
Tool Part
Number
Part Description Qty
A
-
Locking Pin
(Ø 8mm by 85 mm)
1
1. If the engine has fan guards, remove the fan
guards.
g01341758
Illustration 350
2. Install a suitable square drive tool into hole (X) in
tensioner (3). From the front of the engine, turn
the tool in a clockwise direction.
3. Insert Tooling (A) into hole (Y). Release the
pressure on the square drive tool.
4. Remove alternator belt (1).
Note: Mark the direction of rotation if the belt will
be reused.
5. From the front of the engine, turn the square drive
tool in a clockwise direction. Release the pressure
on Tooling (A). Remove Tooling (A) from hole (Y).
6. Release the pressure on the square drive tool and
remove the tool from hole (X).