Perkins 1106C Series, Disassembly And Assembly, Page: 137 / 192

KENR6932 137
Disassembly and Assembly Section
4. Attach a suitable lifting device to engine oil pan (7)
and support the weight of the engine oil pan. The
engine oil pan can weigh 100 kg (220 lb).
5. Use Tooling (A) in order to remove the four torx
screws (11).
6. Remove nuts (10). Remove bolts (8) and (9).
Note: The bolts are different lengths. Note the
position of the different bolts.
7. Use the lifting device to remove engine oil pan (7)
from the cylinder block.
8. Remove joint (4) from the cylinder block.
9. Remove drain plug (5).
10. Remove O-ring seal (6) from oil drain plug (5).
i02654410
Engine Oil Pan - Install
(Cast Iron Oil Pan)
Installation Procedure
Table 62
Required Tools
Tool Part Number Part Description Qty
A
-
T40 Torx Socket
1
C
21826038
POWERPART
Silicon Rubber Sealant
-
D
21820117
POWERPART
Threadlock and Nutlock
-
E
-
Straight Edge 1
Note: In order to install a cast iron oil pan, the engine
must be removed from the application.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fl uids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fl uid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fl uids.
Dispose of all fl uids according to local regulations and
mandates.
1. Ensure that the joint face of the cylinder block is
clean and free from damage. Inspect the studs
in the cylinder block for damage. If necessary,
replace the studs.
2. Ensure that the engine oil pan is clean and free
from damage.
g01340933
Illustration 280
Typical example
3. Apply a bead of Tooling (C) to positions (Y).