KENR6932
57
Disassembly and Assembly Section
End By:
a.
Install the cylinder head. Refer to Disassembly
and Assembly, “Cylinder Head - Install”.
i02654484
Engine Oil Filter Base -
Remove and Install
Removal Procedure
Table 20
Required Tools
Tool
Part Number
Part Description
Qty
A
-
Strap Wrench
1
Note:
The oil
fi
lter can be installed vertically or the oil
fi
lter can be installed horizontally.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that
fl
uids are contained
during performance of inspection, maintenance, test-
ing, adjusting, and repair of the product. Be prepared
to collect the
fl
uid with suitable containers before
opening any compartment or disassembling any com-
ponent containing
fl
uids.
Dispose of all
fl
uids according to local regulations and
mandates.
1.
Place a suitable container below engine oil
fi
lter
base (3) in order to catch any oil that might be
spilled.
g01336008
Illustration 97
Typical example
2.
If the engine oil
fi
lter base has a horizontal engine
oil
fi
lter, follow Steps 2.a to 2.b in order to drain
the engine oil
fi
lter.
a.
Remove drain plug (6) from engine oil
fi
lter
base (2).
b.
Remove O-ring seal (5) from drain plug (6).
3.
Use Tooling (A) to remove engine oil
fi
lter (3).
Refer to Operation and Maintenance Manual,
“Engine Oil and Filter - Change”.
4.
Remove bolts (4). If bolts of different lengths are
installed, identify the correct position of the bolts.
Note:
If necessary, remove the spacers and slide the
bracket for the wiring loom to one side.
5.
Remove engine oil
fi
lter base (2).
6.
Remove joint (1).
7.
If necessary, remove plug (8) from engine oil
fi
lter
base (2). Remove O-ring seal (7) from plug (8).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.