126
KENR6932
Disassembly and Assembly Section
g01340192
Illustration 253
12.
Install bolts (14) to cylinder head (16).
13.
Tighten the bolts to a torque of 50 N·m (37 lb ft) in
the numerical sequence. Refer to Illustration 253.
14.
Tighten the bolts to a torque of 100 N·m (74 lb ft)
in the numerical sequence. Refer to Illustration
253.
15.
Turn the bolts through an additional 225 degrees
in the numerical sequence. Refer to Illustration
253. Use Tooling (B) to achieve the correct
fi
nal
torque.
g01340080
Illustration 254
Typical example
16.
Use Tooling (C) in order to lubricate the O-ring
seals. Install new O-ring seals (12) and (13) to
bypass tube (11). Install the bypass tube in the
cylinder head. Install bolts (10). Tighten the bolts
to a torque of 22 N·m (16 lb ft).
g01340077
Illustration 255
Typical example
17.
Remove the plugs and caps from the ports and
tube assemblies.
18.
Install tube assembly (8) for the fuel return to the
cylinder head and to the transfer pump. Secure
the tube clips for tube assembly (8).
19.
If the engine has a wastegate solenoid, install
tube assembly (9) for the wastegate solenoid to
the cylinder head. Secure the tube clips for tube
assembly (9).
g01340075
Illustration 256
Typical example
20.
Follow Steps 20.a and 20.b in order to connect
harness assembly (4) to inlet air temperature
sensor (7).
a.
Connect harness assembly (4) to inlet air
temperature sensor (7).