KENR6932
145
Disassembly and Assembly Section
g01342059
Illustration 293
d.
Position a new joint (1) onto the isolating frame
(3).
e.
Align the isolating frame (3) with Tooling (B).
Install the isolating frame to the cylinder block.
f.
Use Tooling (A) to install the two torx screws
(2) and the four torx screws (4) to the isolating
frame. Tighten the torx screws (2) to a torque
of 22 N·m (16 lb ft). Tighten the torx screws (4)
to a torque of 22 N·m (16 lb ft).
End By:
a.
Install the engine oil pan. Refer to Disassembly
and Assembly, “Engine Oil Pan - Remove”.
b.
Install the
fl
ywheel housing. Refer to Disassembly
and Assembly, “Flywheel Housing - Remove and
Install”.
i02654527
Piston Cooling Jets - Remove
and Install
Removal Procedure
Table 66
Required Tools
Tool
Part
Number
Part Description
Qty
A
21825576
Crankshaft Turning Tool
1
27610291
Barring Device Housingl
1
A
27610289
Gear
1
Start By:
a.
Remove the engine oil pump. Refer to
Disassembly and Assembly, “Engine Oil Pump
- Remove”.
Note:
Either Tooling (A) can be used. Use the Tooling
that is most suitable.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
1.
If the crankshaft is installed, use Tooling (A) to
rotate the crankshaft in order to gain access to the
piston cooling jet.
g01340939
Illustration 294
2.
Remove bolt (1) and piston cooling jet (2) from
the cylinder block.
3.
Repeat steps 1 and 2 for the remaining piston
cooling jets.