KENR6932
167
Disassembly and Assembly Section
g01341704
Illustration 337
Typical example
1.
Lubricate a new O-ring seal (5) with clean engine
oil. Install the new O-ring seal into the
fi
rst groove
in position sensor (3).
2.
Remove the plug from the hole in the fuel injection
pump for the position sensor.
3.
Align the hole in position sensor (3) with the hole
in the fuel injection pump. Install the position
sensor to the fuel injection pump.
Note:
Do not use bolt (4) to pull the position sensor
into position against the fuel injection pump.
4.
Install bolt (4). Tighten the bolt to a torque of
22 N·m (16 lb ft).
5.
Connect harness assembly (2) to position sensor
(3).
6.
Slide locking tab (1) into the locked position.
i02654460
Coolant Temperature Sensor -
Remove and Install
Removal Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that
fl
uids are contained
during performance of inspection, maintenance, test-
ing, adjusting, and repair of the product. Be prepared
to collect the
fl
uid with suitable containers before
opening any compartment or disassembling any com-
ponent containing
fl
uids.
Dispose of all
fl
uids according to local regulations and
mandates.
1.
Drain the coolant from the cooling system, to a
level below the coolant temperature sensor, into
a suitable container for storage or for disposal.
Refer to Operation and Maintenance Manual,
“Cooling System Coolant - Change” for the correct
draining procedure.
g01341684
Illustration 338
2.
Slide locking tab (1) into the unlocked position.
3.
Disconnect harness assembly (2) from coolant
temperature sensor (3).
4.
Use a deep socket in order to remove coolant
temperature sensor (3) from the cylinder head.
5.
Remove O-ring seal (4) from the coolant
temperature sensor (3).
Installation Procedure
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.