100
KENR6932
Disassembly and Assembly Section
4.
Install thrust washer (10) into the recess
in the cylinder block. Refer to Disassembly
and Assembly, “Camshaft - Install” for more
information.
g01338000
Illustration 191
5.
Install Tooling (B) to the cylinder block. Refer to
Illustration 191.
6.
Align a new joint (6) with Tooling (B). Install the
joint to the cylinder block.
Note:
Ensure that two circular tabs (X) on the joint
are engaged in two holes (Y) in the cylinder block.
g01338001
Illustration 192
Typical example
7.
Install Tooling (C) to the cylinder block.
8.
Install the front housing over Tooling (B) and
Tooling (C) onto the cylinder block.
g01338002
Illustration 193
(7) M8 by 20 mm
(8) M8 by 35 mm
(9) M8 by 25 mm
9.
Install bolts (9) to front housing (3)
fi
nger tight.
10.
Remove Tooling (B).
11.
Loosely install bolts (7) and (8). Refer to
Illustration 193 for the correct position of the bolts.
12.
Align the bottom face of front housing (3) to the
lower machined face of the cylinder block. Use a
Tooling (D) and a feeler gauge in order to check
the alignment between the front housing and the
cylinder block. Refer to Illustration 192. Refer to
Speci
fi
cations, “Front Housing and Covers” for
further information.