Perkins 1106C Series, Disassembly And Assembly, Page: 58 / 192

58 KENR6932
Disassembly and Assembly Section
g01336008
Illustration 98
Typical example
1. Clean engine oil fi lter base (2). Clean the mating
surfaces of the cylinder block or the engine oil
cooler.
2. If necessary, install new O-ring seals (5) and (7)
to plugs (6) and (8). Install plugs (6) and (8) to
engine oil fi lter base (2). Tighten the plugs to a
torque of 12 N·m (106 lb in).
Note: Drain plug (6) is only installed to engines with
a horizontal engine oil fi lter.
3. Install bolts (4) to engine oil fi lter base (2). Ensure
that bolts of different lengths are installed in the
correct positions.
Note: If necessary, install the spacers and the
bracket for the wiring loom.
4. Install a new joint (1) onto bolts (4). Install the
assembly of the engine oil fi lter base to the
cylinder block or the engine oil cooler.
5. Tighten bolts (4) to a torque of 22 N·m (16 lb ft).
6. Install a new engine oil fi lter (3) and check the level
of the engine lubricating oil. Refer to Operation
and Maintenance Manual, “Engine Oil Level -
Check” for the correct procedure.
i02654366
Engine Oil Cooler - Remove
(Engine Oil Cooler with a Low
Mounted Filter Base)
Removal Procedure
Start By:
a. Remove the bracket for the Electronic Control
Module. Refer to Disassembly and Assembly,
“ECM Mounting Bracket - Remove and Install”.
NOTICE
Ensure that all adjustments and repairs that are
carried out to the fuel system are performed by
authorised personnel that have the correct train-
ing.
Before begining ANY work on the fuel system, re-
fer to Operation and Maintenance Manual, “Gen-
eral Hazard Information and High Pressure Fuel
Lines” for safety information.
Refer to System Operation, Testing and Adjusting,
“Cleanliness of Fuel System Components” for de-
tailed information on the standards of cleanliness
that must be observed during ALL work on the fu-
el system.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
NOTICE
Care must be taken to ensure that fl uids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fl uid with suitable containers before open-
ing any compartment or disassembling any compo-
nent containing fl uids.
Dispose of all fl uids according to local regulations and
mandates.
1. Drain the coolant from the cooling system into
a suitable container. Refer to Operation and
Maintenance Manual, “Cooling System Coolant -
Drain” for the correct procedure.