Panasonic KX-TVP50E, Installation Manual

Page: 187 / 368

SYSTEM ADMINISTRATOR'S GUIDE
Installation Manual 187
Notification Setting - Device 1-3
Table 36
Parameter Value Range
(Default)
Description/Function
Dial Number Up to 32 digits
consisting of 1-9,
0, , #
P, T, M, X
(None)
Assigns a telephone or beeper (pager) number to
Device 1, 2, or 3. The subscriber can also specify the
dial number from his telephone.
P: Pause
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse, or
Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note : The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS and
"Type of Device" is set to "Beeper." The proper number
of "Pauses" must be inserted before the callback entry
code.
The Subscriber can also specify the dial number.
Type of Device 1. Telephone
2. Beeper
(Telephone)
Specifies the device to be notified. This is
automatically set to "Beeper" when "X" is used in the
Dial Number (above). The Subscriber can also specify
the type of device from his telephone.
Use Mode 1. Not Use
2. Continuously
3. Scheduled
(Continuously)
Specifies how Device 1, 2, or 3 is to be used. The
Subscriber can also specify the use mode from his
telephone.
1.Not Use - Device 1, 2, or 3 is not used for a
notification call.
2.Continuously - Device 1, 2, or 3 is called whenever a
message is recorded in the mailbox.
3.Scheduled - Device 1, 2, or 3 is called on a schedule
basis when a message has been left in the mailbox.
No. of Retries 0-4 times
(0)
Specifies the number of times that a notification call to
Device 1, 2, or 3 should be attempted after a busy or no
answer condition is received
Busy Delay
Time 2-120 min
(3)
Specifies the time (in minutes) the VPS must wait after
a busy condition is received before making a
notification call to Device 1, 2, or 3.