Panasonic KX-TVP50E, Installation Manual

Page: 59 / 368

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
Installation Manual 59
CAUTION
Setting the DIP switch to position 5 will default the Voice Processing System, resulting in a
loss of all user programming, and voice messages (except User 1 and User 2 prompts).
9.
Plug in and power up the KX-TVP50 and wait approximately 3.5 min while the system
initialises.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
• The Power Indicator light goes on.
• The Power Indicator light begins to flash.
• "Checking Flash Memory Cards." is displayed on the screen.
Screen output:
• The VPS tests the CPU card, the flash memory, and the ports
until "1...2...3..." is displayed.
• Active ports are displayed on the screen.
Screen output:
This message is shown when the digital (APT) connection between the VPS and
telephone system cannot be established. This is normal. This message appears because
the PBX type for the VPS is not a KX-TA series system. Since the default PBX type is
set to the KX-TD816/1232/612 at the factory, this message will always appear. To
change the default, go to the
System Administration Top Menu , and Type1-6-3-1.
(Program - Hardware Settings - PBX Interface Parameters - Dialing Parameters Menu).
Select "2:KXT Series" and then "7:TA series" at the "1. PBX Type", and select "3:APT"
at the "2. Integration Mode".
Exit the menu by entering "\", and the following display will be shown.
PORT TEST...
SYSTEM SETUP
1... 2... 3...
Checking Flash Memory Cards.
Please wait...
Active COs: 1 2
DPT Interface Connection is not Established
** OFF LINE MODE **