Panasonic KX-TVP50E, Installation Manual

Page: 60 / 368

INTEGRATING THE VPS WITH THE PANASONIC KX-TA ANALOGUE PBX AND KX-TD DIGITAL PBX
60 Installation Manual
Screen output:
If "APT Interface Connection is not Established" is still shown, possible causes
are:
10.
Start up completed.
a)
The Power Indicator light stops blinking when the start-up has been successful. (The
delay varies according to the system's condition.)
b)
"**ON LINE MODE**" is displayed.
c)
System prompt [>] is displayed on the screen. To enter system administration, Press
ENTER . All parameters can be set through the menu-driven program.
11.
Go to the System Administration Top Menu. Type
[5]
and
Press ENTER
, or Type
[3]
then
QSET
and
Press ENTER
for Quick Setup and follow the Auto Configuration Instructions.
Table 15
Cause Action
The cabling between the PBX
extension ports and the VPS is not 4-
wire or is improperly connected. Confirm the cabling is
connected as described in
Section 2 INSTALLATION.
The PBX is a KX-TA series but does
not have the proper level of software
required to support APT Integration. Consult your dealer or use
Inband Integration under
hardware settings.
The PBX is not programmed properly
to support APT Integration. Do required integration
programming as described in
this chapter.
** OFF LINE MODE **