Panasonic KX-NS300, User Manual

Page: 334 / 388

Notification Parameters
Item Description
Message Waiting Lamp If set to "Enable", the Message Waiting Lamp of your telephone turns on
when a new message is recorded.
Telephone
Device—Device No. 1, 2, 3 Specifies the Message Waiting Notification schedule for each device.
The following parameters can be specified for devices 1, 2, and 3.
Click
Edit for the extension to change, set Device Notification for
Unreceived Message to "Yes", and set program the settings, then click
OK to finish.
Only Urgent Messages
Specifies if notifications will be sent only for messages designated as urgent.
Dial Number [0-9 * # T X , ;]
Assigns a telephone number to Device 1, 2, or 3. You can also specify the
number to be dialled by entering it from your telephone, allowing you to set
this feature on a case by case basis.
Enter a maximum of 32 digits consisting of 0–9, , # and special codes:
•
, : Dial Pause (default 1 s)
•
; : Dial Pause (default 3 s)
•
T : Dial Tone Detection
•
X : Callback Number Entry Code
•
0–9, , # : Dial Code
Note
If you are using a PRI line, you may need to enter # at the end of outside
telephone numbers.
No. of Retries
Specifies the number of times the Unified Messaging system will try to send
notification if the device is busy or if there is no answer.
Busy Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits before
retrying message notification when the called device is busy.
No Answer Delay Time (min)
Specifies the time (in minutes) the Unified Messaging system waits before
retrying message notification when the called device does not answer.
334 User Manual
3.2.1 User Programming