![background image](http://html1.mh-extra.com/html/oval/el-2310-05e-series/el-2310-05e-series_manual_1662133021.webp)
E-022-4-E
2
Fig.34
Fig.3
Fig.36
3.6.6 Status Input
①
Click on "Setup (S)" at top-level menu of the screen, select "Status input" from "Config output" drop-
down list, and click on again.
②
A message box as shown in Fig. 34 appears. Status input function is set up at this window.
③
By clicking on the arrow mark at right, select the function to be set up from the drop-down list as shown
in Fig. 3.
④
You can select the status input from three functions-"0% Signal Lock"
,
"Auto Zero" and "Reset
Totalizer"
.
・
"0% Signal Lock" : Forcibly locks individual outputs at 0%.
・
"Auto Zero" : Zeroes from a terminal in a remote location (remote zero).
・
"Reset Totalizer" : Reset the totalizer from a terminal in a remote location.
Default setting is "No Function"
.
To disable the status input function, select "No Function"
.
⑤
You can select the status input from two types of input- "a" form contact input or "b" form contact input.
・
"Short Active" : "a" form contact input
・
"Open Active" : "b" form contact input
Default setting is "Short Active"
.
After filling in all the fields required, click on "OK" button. A message box as shown in Fig. 36 then
appears. Clicking on "OK" at this window changes the previous settings to the new settings just
entered. However, the flowmeter output also changes with the changes in settings made. For safety's
sake, therefore, in applications where the flowmeter output controls a valve (s) or other devices, it
is necessary that the control loop be switched to manual control to ensure that the control loop is
unaffected by the flowmeter output.
Summary of Contents for EL 2310-05E Series
Page 71: ...E 022 4 E 71...