![background image](http://html1.mh-extra.com/html/oval/el-2310-05e-series/el-2310-05e-series_manual_1662133032.webp)
E-022-4-E
32
Fig.62
③
After filling in all the fields required, click on "OK" button. A message box as shown in Fig. 62 then
appears.
Clicking on "OK" at this window changes the previous settings to the new settings just entered.
However, the flowmeter output also changes with the changes in settings made. For safety's sake,
therefore, in applications where the flowmeter output controls a valve or other devices, it is necessary
that the control loop be switched to manual control to ensure that the control loop is unaffected by the
flowmeter output.
④
When the previous settings are replaced with the new settings just entered in response to clicking on
"OK"
,
a message box as shown in Fig. 63 appears. Clicking on "OK" button at this point completes the
setup.
Fig.63
CAUTION:
Flowmeter calibration factor has already been set up before shipment from the factory
and no further adjustment is required. Do not attempt to change the setting unless
recalculating is absolutely necessary.
3.6.14 Density Factor (Density Cal)
①
Click on "Setup (S)" at top-level menu of the screen, select "Density Cal" from "Charize sensor" drop-
down list, and click on again.
②
A message box as shown in Fig. 64 appears. At this window, density factors are set up.
⑤
After clicking on "OK" button, the message box for filling in fields of individual items appears again.
Click on "Cancel" button to hide the message box for filling in fields of items.
To abort the setup process, click on "Cancel" button in the course of steps
②
through
③
.
Fig.64
Summary of Contents for EL 2310-05E Series
Page 71: ...E 022 4 E 71...