4
Specifications
Section 1-3
Last Maintenance Date
The dates on which maintenance is performed can be written to the
DeviceNet Communications Unit. The recorded date shows when mainte-
nance is required next.
1-2-2
System Configuration
The DeviceNet Communications Unit connects to the Master by a network
cable and it connects to the Slice I/O Units by directly coupling the Units with
slide connectors.
The I/O Unit data in the DeviceNet Communications Unit is shared with the
Master’s Input and Output Areas through the DeviceNet network. The I/O
Units’ data is collected in the DeviceNet Communications Unit and exchanged
with the Master asynchronously.
It is also possible to send explicit message commands addressed to the
DeviceNet Communications Unit.
Note
Always install an End Unit on the last I/O Unit in the last node.
1-3
Specifications
1-3-1
Communications Specifications
CS/CJ-series DeviceNet Unit (master)
DeviceNet
PLC
Serial connection
(For setting, monitoring, and operating)
CX-One (CX-Integrator)
Explicit messages
Used to monitor operation and write
parameters to the Slice I/O Units or
DeviceNet Communications Unit.
Remote I/O communications
I/O data is collected from
the connected Slice I/O
Units and exchanged in a
batch with the Master.
I/O data first goes to the
Communications Unit.
Slave
GRT1-DRT DeviceNet
Communications Unit
I/O Units
GRT1-TBR Right Turnback Unit
GRT1-TBL Left Turnback Unit
GCN2-100 Turnback Cable (1 m)
GRT1-END End Unit
Up to 64 Slice I/O Units can be connected to one DeviceNet Communications Unit.
Up to 2 sets of Turnback Units
can be used per Communications Unit
Item
Specification
Number of connectable Slice
I/O Units
64 Units max.
Baud rate
3 Mbps
Communications signal level
RS-485
Turnback Cable
Length 1 m max., up to 2 cables can be connected.
Summary of Contents for SMARTSLICE - 04-2008
