21
Node Address Settings and I/O Allocation
Section 2-2
2.
Click the
Advanced Setup
Button, click the
Connection
Tab, and select
User Setup
. Select
Use Poll Connection
and
Use COS Connection
and
then select
output data
,
input data
, and
generic status
for the respective
connection paths. In this example, the IN size for COS connection is set to
generic status
, the IN size for poll connection is set to
input data
, and
OUT size for poll connection is set to
output data
.
3.
Click the
OK
Button.
Note
If there are checks in the check boxes but the connection path settings are left
blank, the following settings will be made automatically.
IN (Smart Slave to Master Unit)
OUT (Master Unit to Smart Slave)
Poll
Input Data + Generic Status
Output Data
Bit-Strobe
Input Data + Generic Status
Not set.
COS
Input Data + Generic Status
Not set.
Cyclic
Input Data + Generic Status
Not set.
Summary of Contents for SMARTSLICE - 04-2008
