Omron SMARTSLICE - 04-2008, Operation Manual

Page: 71 / 122

52
Basic Operating Procedure and Example Configuration Section 4-1
4-1 Basic Operating Procedure and Example Configuration
This section outlines the basic procedure for using a Slice I/O Terminal in a
DeviceNet network and describes the basic configuration.
4-1-1 Basic Operating Procedure
The following lists outline the basic operating procedures. Refer to the refer-
ence pages provided for details on each step and refer to the DeviceNet mas-
ter operation manual or
GRT1 Series Slice I/O Units Operation Manual when
necessary.
Preparation
Setting Up Hardware and
Wiring
Starting Communications
Confirming Operation
Note This section shows the minimum settings required to operate a Slice I/O Ter-
minal. Refer to the DeviceNet master operation manual and
GRT1 Series
Slice I/O Units Operation Manual when more advanced settings are required
for the actual application.
Determine Slice I/O Unit I/O specifications. (See page 53.)
↓
Select the Slice I/O Units. (See page 53.)
↓
Confirm the specifications. (See page 53.)
Determine wiring methods. (See page 54.)
↓
Determine the power supply method. (See page 54.)
↓
Layout cable.
↓
Setup and install Master Unit. (See page 55.)
↓
Setup and install Slice I/O Terminal. (See page 55.)
↓
Connect cables. (See page 57.)
↓
Create the I/O table. (See page 57.)
↓
Start the system. (See page 58.)
↓
Create and register the Slice I/O table. (See page 58.)
↓
Check the Unit’s LED indicators (See page 60.)
↓
Write data to check operation. (See page 60.)
↓