Omron R6YXC1000, User Manual, Page: 85 / 260

4
I/O interf
ace
4-3
1.3 Power connector wiring work
■
Stripping the electric wire
Strip the electric wire sheath 7 mm.
7 mm
Perform the work while referring to the figures shown below.
■
When using the finger operation lever
Push the finger operation lever
installed on the top by finger to
push down the spring. 1. Insert the electric wire all the way
from the insertion port while
pushing the operation lever. 2. Release the operation lever.
To check the connection, lightly
pull the electric wire. 3.
■
When using a screwdriver (front entry)
Insert a screwdriver into the
operation slot (square hole).
When the screwdriver is inserted
correctly, it is then held. Insert the electric wire that has
been stripped correctly all the way
to the wire hole (round hole). 2. Remove the screwdriver.
To check the connection, lightly
pull the electric wire. 3. 1.