Omron R6YXC1000, User Manual, Page: 211 / 260

A
Troubleshooting
A-29
6.260 : Too many characters
Code : &H0006 &H0104
Meaning/Cause
a. The number of defined character constants exceeds 255.
b. The number of addition characters exceeds 255.
Action
a. Define the number of character constants within 255.
b. Set the number of additional characters within 255.
6.261 : Task stopped
Code : &H0006 &H0105
Meaning/Cause The task is in stop status.
Action Restart the task by "RESTART" statement.
6.262 : Task doesn't exist
Code : &H0006 &H0106
Meaning/Cause The task is not executed.
Action Start the task by "START" statement.
6.263 : Too many Tasks
Code : &H0006 &H0107
Meaning/Cause The number of programs has exceeded the upper limit (16).
Action Release the task by "EXIT TASK" statement or "CUT" statement, then register a task.
6.264 : Type mismatch
Code : &H0006 &H0108
Meaning/Cause
a. Expression types are not equal on both sides.
b. Prohibited type constant/variable/expression was used.
Action
a. Use the same expression type on both sides.
b. Use a correct type of constant/variable/expression.
6.265 : Timeout
Code : &H0006 &H0109
Meaning/Cause
a. Servo off/free of the axis has not completed.
b. Mark setting has not completed.
c. Servo on/off of the gripper has not completed.
Action
a. Check the axis connection.
b. Check the mark axis connection.
c. Check the gripper connection.
6.266 : All axes completed
Code : &H0006 &H010A
Meaning/Cause Return-to-origin has completed on all axes.
Action It is not necessary to perform return-to-origin.
6.267 : Access level error
Code : &H0006 &H010B
Meaning/Cause The operation cannot be executed at the present access level.
Action Change the access level so that the operation can be executed.