Omron NC1-510000, User Manual

Page: 146 / 188

6-1 Power ON
This section provides Power ON details.
6-1-1
Power ON Using the Power Button
Start condition: Power is supplied to the AMR Controller and the AMR Controller is OFF.
1
Press the power button and release within 1 second.
Refer to
3-4 Power Button on page 3-11 for the power button location.
The AMR Controller starts and the PWR LED will turn ON.
2
Wait until the PWR LED is ON and verify that the ERR LED is OFF.
The AMR Controller is ON and the Operating System, if installed, starts.
6-1-2
Power ON Using the Power ON/OFF Input
Start condition: Power is supplied to the AMR Controller and the AMR Controller is OFF.
1
Supply an input signal to pins 3 and 4 of the I/O connector.
The input signal must remain ON for a minimum of 60 ms and a maximum of 750 ms to be
correctly detected by the AMR Controller.
The AMR Controller starts and the PWR LED will turn ON.
2
Wait until the PWR LED is ON and verify that the ERR LED is OFF.
The AMR Controller is ON and the Operating System, if installed, starts.
Additional Information
• Refer to 4-2-2 I/O Connector Specifications on page 4-12 for connector specifications.
• Refer to 5-4-4 Wire the I/O Connector on page 5-31 for wiring details.
6-1-3
Auto Power ON
The AMR Controller can be configured to start up when power is supplied to the power connector.
The
Power Loss Control BIOS setting controls this behavior.
Set the Power Loss Control setting to Turn ON to activate the Auto Power ON function.
Additional Information
Refer to A-1 BIOS on page A-2 for BIOS details.
6 Operating Procedures
6-2
AMR Controller User's Guide (I650)