Omron NC1-510000, User Manual

Page: 116 / 188

5-3-8
Book Mount Procedure
Use the following procedure to mount the AMR Controller in the book orientation.
Additional Information
• Refer to 5-4-2 Ground on page 5-20 for grounding details.
• Refer to 3-10-1 Mounting Brackets on page 3-24 for the bracket model.
To mount the AMR Controller:
1
The AMR Controller has on one side light grey circles around the threaded mounting holes.
The bookmount bracket has on the inside on one side also the light grey circles around the
mounting holes.
The light grey circles are contact areas that ensure a good electrical conductivity.
Position the AMR Controller inside the bracket so the light grey circles of the bookmount brack-
et contact the light grey circles of the AMR Controller.
2
Mount the bracket
A
to the AMR Controller
C
with the 6 Phillips screws
B
supplied with the
bracket.
First tighten the 3 screws at the side of the contact areas with a torque of 0.6 N·m.
Then tighten the 3 screws at the opposite side, also with a torque of 0.6 N·m.
A
B
C
0
15
The bracket and the AMR Controller can differ depending on the product configuration.
3
Mount the AMR Controller with the bracket in position.
• Arrange the two or four holes at the location where the AMR Controller with bracket will be
mounted.
Refer to
4-1-8 Bracket Specifications on page 4-8 for details.
• Position the AMR Controller with bracket in the mounting location.
• Insert screws through the bracket and into or through the mounting surface.
Note that these screws are not in the scope of delivery.
• Tighten the screws with a torque matching the screw size and the mounting materials.
The AMR Controller is mounted.
5 Installation
5-18
AMR Controller User's Guide (I650)