Omron NC1-510000, User Manual

Page: 140 / 188

USB
USB
Industrial PC
Input
24 VDC Power Supply (S8VK)
AC (L)
AC (N)
24 VDC
0 VDC
UPS (S8BA) Output
Refer to the UPS S8BA User's Manual (Cat. No. U702) for details.
Refer to 5-4-3 Wire the Power Connector on page 5-27 for wiring details.
4
Supply power to the Power Supply.
5
Press and hold the UPS power button until On appears on the UPS display.
6
Power ON the AMR Controller and then wait until the device drivers are successfully installed.
7
Configure the UPS using the UPS Settings Utility.
Refer to
UPS Setting Utility Instruction Manual for S8BA/BU-2RWL for details.
8
Install the Power Attendant Lite Utility.
9
Configure the UPS using the Power Attendant Lite Utility.
10
Configure the AMR Controller to auto-start after power loss within the BIOS settings.
Refer to
A-1 BIOS on page A-2 for BIOS details.
11
Simulate a power interruption and confirm a correct shutdown of the AMR Controller.
• Start the AMR Controller
• Start applications
• Create a power interruption
• Monitor the shutdown sequence and confirm a correct shutdown sequence
The UPS is connected and configured.
The AMR Controller will shut down properly in case of a power supply interruption and restart automat-
ically when the power is restored.
Additional Information
• The default Input sensitivity setting is Standard voltage sensitivity and this is correct.
Do not set this parameter to Low voltage sensitivity . Doing so can cause a system malfunc-
tion when switching to battery mode.
• The UPS Setting Utility can not be used when the Power Attendant Lite Utility is active.
To use the UPS Setting Utility:
1. Right-click the Power Attendant Lite Utility icon and select Agent Stop.
2. Use the UPS Setting Utility.
3. Right-click the Power Attendant Lite Utility icon and select Agent Start.
5 Installation
5-42
AMR Controller User's Guide (I650)