5. Installation and Wiring
5-10
■
Input/Output Devices
For selection and connection of devices to the general-purpose input/output terminals,
refer to the followings:
●
Example of Input Device and EQ100 Internal Circuit
●
Example of Output Device and EQ100 Internal Circuit
LAN Connection Port
5.5.4.
To connect EQ100 to a computer, connect a LAN cable to the following LAN connection port.
Precautions for
Correct Use
- To the sub-LAN port of EQ100, an upper level system cannot be connected, such as the EQ
server, SMTP server, SNTP server, and FTP server.
- If you wish to perform maintenance of a sensor that is connected to the sub-LAN port of
EQ100 using the software attached to the sensor, use a computer connected to the network
on the sub-LAN.
Precautions
- Keep a little room upon wiring of a LAN cable to the LAN port.
- It should make easier the dismounting task of EQ100 for battery replacement.
5ms 5ms
入力最小パルス幅
5ms
Minimum Input Pulse Width
Power for Input
Input(+)
Input(-)
EQ100 Internal Circuit
Input Device
Open Collector Contact
Zener Diode
(33 V)
)
Output(-)
Load
EQ100 Internal Circuit
Zener
Diode
(39V)
10.2 to 26.4 VDC
30 VDC (max.)
50 mA (max.)