![background image](http://html1.mh-extra.com/html/omron/cx-motion-ncf-v1-9/cx-motion-ncf-v1-9_operation-manual_744182009.webp)
ix
About this Manual:
This manual describes the installation, and operation of the CX-Motion-NCF software package and
includes the sections described below. The CX-Motion-NCF runs on Windows 2000, XP, and Vista and
is used to set and transfer data used by CS1W-NCF71/CS1W-NC471/CS1W-NC271/CJ1W-NCF71/
CJ1W-NC471/CJ1W-NC271 Position Control Units (also referred to as NC Units), save and print the
Position Control Unit data, and monitor the Position Control Unit’s operating status.
Please read this manual carefully and be sure you understand the information provided before
attempting to install or operate the CX-Motion-NCF. Be sure to read the precautions provided in the fol-
lowing section. Please read the following manuals carefully and be sure you understand the informa-
tion provided before setting up or using an application for a Position Control Unit.
For details on procedures for installing the CX-Motion-NCF from the CX-One FA Integrated Tool Pack-
age, refer to the
CX-One Ver. 3.0 Setup Manual
provided with CX-One.
Name
Contents
Cat. No.
(suffixes omitted)
SYSMAC CX-Motion-NCF
Operation Manual
Describes the operating procedures for the CX-Motion-NCF W436 (this manual)
SYSMAC CJ1W-NCF71/
CS1W-NCF71/
Position Control Units
Operation Manual
Describes the basic operation of the Position Control Units.
W426
Cat. No.
Model
Name
Contents
W463
CXONE-AL
@@
C-V3/
CXONE-AL
@@
D-V3
CX-One Ver. 3.0 Setup
Manual
Installation and overview of CX-One FA Inte-
grated Tool Package.
Summary of Contents for CX-MOTION-NCF - V1.9
