![background image](http://html1.mh-extra.com/html/omron/cx-motion-ncf-v1-9/cx-motion-ncf-v1-9_operation-manual_744182089.webp)
65
Comparing Data
Section 7-5
2.
Click the
OK
Button.
If the communications between the Position Control Unit and Servo Drive
are not established at this point, the following dialog box will be displayed
to confirm whether to establish the connection or not.
3.
Click the
OK
Button to establish the communications and start uploading
Servo Parameters.
4.
If the Servo Drive models do not match, the following confirmation mes-
sage will be displayed. To continue uploading, click the
OK
Button.
5.
Clicking the
Cancel
Button during comparing will cancel comparing.
6.
If the connection was established in step 2, the connection status can be
restored (released in this case) here. To release the connection, click the
OK
Button. To leave the connection established, click the
Cancel
Button.
7.
After completion of comparing, the following dialog box will be displayed if
Servo Parameters have no mismatch.
Summary of Contents for CX-MOTION-NCF - V1.9
