60
Uploading Data
Section 7-4
Note
When the axis map on the computer is different from the scan list in the Posi-
tion Control Unit, Unit Parameters will not be uploaded. Execute batch upload
instead.
7-4-3
Uploading Servo Parameters
1,2,3...
1.
Click the
Upload
Button in the Edit Servo Parameter Window. The follow-
ing dialog box will be displayed.
2.
Click the
OK
Button.
If the connection between the Position Control Unit and Servo Drive are not
established at this point, the following dialog box will be displayed to con-
firm whether to establish the connection or not.
3.
Click the
OK
Button to establish communications and start uploading Ser-
vo Parameters from the Servo Drive.
4.
If the Servo Drive models do not match, the following confirmation mes-
sage will be displayed. To continue uploading, click the
OK
Button.
5.
Click the
Cancel
Button to cancel uploading.
6.
If the connection was established in step 2, the connection status can be
restored (released in this case) here. To release the connection, click the
OK
Button. To leave the connection established, click the
Cancel
Button.
Summary of Contents for CX-MOTION-NCF - V1.9
