Omron CX-MOTION-NCF - V1.9, Operation Manual

Page: 14 / 147

xiv
Improvements from Version 1.3 to Version 1.4
New Applicable Hardware
Improvements from Version 1.2 to Version 1.3
Setting Up an Absolute Encoder
New Applicable Hardware
Note Only FQM1 Flexible Motion Controllers with unit version 3.0 or later are sup-
ported.
Improvements from Version 1.1 to Version 1.2
Installing the CX-Motion-NCF from the CX-One FA Integrated Tool Package
CX-Motion-NCF Startup Method
Improvements from Version 1.0 to Version 1.1
Supporting New Models of W-series Servo Drive
Item Ver. 1.3 Ver. 1.4
Position
Control
Units Functions in Position Con-
trol Units with unit version
1.3 or earlier are supported Functions in Position Control Units with unit version 2.0 or earlier are sup-
ported.
•
Origin Search Operation Mode has been added.
•
Preset function for origin searches has been added.
Applicable
Servo
Drives W-series Servo Drives
W-series Servo Drives with
Built-in MECHATROLINK-II
Communications W-series Servo Drives
W-series Servo Drives with Built-in MECHATROLINK-II Communications and
SMARTSTEP Junior Servo Drives with Built-in MECHATROLINK-II Communi-
cations
Ver. 1.2 Ver. 1.3
An absolute encoder could not be set up. An absolute encoder can be set up by communicating through the Position
Control Unit.
Item Ver. 1.2 Ver. 1.3
Position
Control
Units CJ1W-NCF71 CJ1W-NCF71 and CS1W-NCF71
PLCs CJ-series PLCs CS/CJ-series PLCs, CP-series PLCs, NSJ-series NSJ Controllers, and FQM1
Flexible Motion Controllers (See note.)
Ver. 1.1 Ver. 1.2
The CX-Motion-NCF could be installed
only independently. The CX-Motion-NCF can be installed as one of the functions of the CX-One
Integrated Tool Package.
Ver. 1.1 Ver. 1.2
The CX-Motion-NCF could be started
only from the Windows Start Menu. The CX-Motion-NCF can also be started by right-clicking the following Position
Control Unit in the I/O Table Window opened from the CX-Programmer that
was installed from the CX-One and selecting
Start Special Application from
the pop-up menu.
• CJ1W-NC71
Note When Start with Settings Inherited is selected, a new project will be
created and a Position Control Unit will be automatically added.
Item Ver. 1.0 Ver. 1.1
Applicable Servo Drives W-series Servo Drives W-series Servo Drives
W-series Servo Drives with Built-in MECHA-
TROLINK Communications