Omron CX-MOTION-NCF - V1.9, Operation Manual

Page: 121 / 147

97
Error Codes Section 11-2
Position
Control Unit
settings
and opera-
tions errors Illegal data Initializa-
tion axis
parameter
check error 3090 An illegal set value
has been detected in
the Axis Parameters
during Position Con-
trol Unit initialization. When this error occurs, the corresponding
setting in the Axis Parameters is set to the
default value (0). Execute ERROR RESET,
and then transfer the correct Axis Parame-
ter.
Data trans-
fer axis
parameter
check error 3091 An illegal set value in
the Axis Parameters
was transferred to
the Position Control
Unit using WRITE
DATA. The transferred set value is discarded and
the set value in the Axis Parameters before
the transfer is restored. Execute ERROR
RESET, and then transfer the correct Axis
Parameter.
Data setting
error 3099 An attempt was
made to transfer
data for an illegal
parameter number
and outside the set-
ting range using
SERVO PARAME-
TER TRANSFER. The transferred set value is discarded and
the set value for the Servo Parameter
before the transfer is restored. Execute
ERROR RESET, and then transfer the cor-
rect Servo Parameter.
Category Error name Error code Probable cause Clearing method