58
TRANSMISSION
If you want to delete the entire setting press CLEAR .
If you want to change one of the digits set, move the
cursor to the digit to be changed (using the < or > key)
and overwrite it with the new digit.
5.
Press SET/CONF. to confirm the time set.
6.
Press SET/CONF.
The display shows the message “TX SETUP” for a
few seconds and is set for entry of the correspondent’s
facsimile number.
7.
Call the correspondent in one of the three ways listed
below:
By pressing the DIAL key, typing the facsimile number
on the numeric keypad and pressing START to
confirm, or:
by pressing the one-touch dialling key under which
the number was stored or:
by pressing SPEED DIAL followed by the speed
dialling code under which the number was stored.
(The operating procedures summarized above, are
explained in greater detail in the “NORMAL
TRANSMISSION FROM THE ADF” section).
If the AUTOMATIC STORAGE parameter has been
enabled, the document will be stored automatically.
Having finished dialling the number, the message
“*TX ADF ACTIVE” appears on the first line of the
display and “DOC. INSERTED” appears on the second
line.
This message indicates that a transmission operation
is in progress and that the document is present in the
ADF. If the message “*TX ADF ACTIVE*” appears (in
place of the date and time), this means that the
document has been removed from the ADF, so
remember to reinsert it.
If the “LAST TX REPORT” parameter has been
enabled in the operating configuration, the facsimile
machine will print the report at the end of transmission.
T X S E T U P
D I A L / K E Y / S P . D I A L
cap09.p65
13/04/00, 22.30
58
