16
➍
Load the paper in the printer .
Make sure the roll is oriented correctly .
Prepar
ing f
or First-time Oper
ation
4
17
Loading Labels
The label installation method differs by printing mode.
Continuous printing mode
Label paper
Journal paper
(See figure on P. 40)
Label guide stopper
1
Slide the cover release lever in
the arrow direction to open the
cover.
First, slide the dispenser unit to the
continuous printing mode position.
(See P. 21)
2
While pressing the label guide
stopper, slide the label guide to
the label size to be used.
3
Load the paper in the printer.
Make sure the roll is oriented correctly.
➎
Confirm that the label roll can be
rotated easily by hand .
If rotation is labored, this can cause a feed
error . Remove the label roll and adjust the
label guide. Note that the label guides do
not require adjustment when using labels
with the same width .
Prepar
ing f
or First-time Oper
ation
4
18
5
Check that the label tip is
protruding. Then close the main
cover by pressing the middle of
the cover.
Close the main cover slowly, while
pulling the cover release lever.
4
Confirm that the label roll can be
rotated easily by hand.
If rotation is labored, this can cause a
feed error. Remove the label roll and
adjust the label guide. Note that the
label guides do not require adjustment
when you are using labels with the
same width.
This completes loading the labels for continuous printing mode.
➏
Check that the label tip is
protruding (10 mm or more). Then
close the main cover by pressing
the middle of the cover .
Close the main cover slowly, while pulling
the cover release lever .
Prepar
ing f
or First-time Oper
ation
4
18
5
Check that the label tip is
protruding. Then close the main
cover by pressing the middle of
the cover.
Close the main cover slowly, while
pulling the cover release lever.
4
Confirm that the label roll can be
rotated easily by hand.
If rotation is labored, this can cause a
feed error. Remove the label roll and
adjust the label guide. Note that the
label guides do not require adjustment
when you are using labels with the
same width.
This completes loading the labels for continuous printing mode.
➐
For non-separated labels, press
the FEED button to feed one sheet,
and pull upward to tear along the
perforated line .
If the labels clog at the label dispenser,
restart the label loading process from the
beginning
