NEC N8100-1078F, User Manual

Page: 249 / 332

Upgrading Your Server 9-31
8.
Secure four screws to fix the heat sink.
NOTE:
Tighten four screws temporarily in the following order shown
in the figure below, and then completely tighten all screws.
9.
Make sure that the heat sink is level.
NOTES:
„
If the heat sink is not level, remove it, and then install it again. The
following probably causes the heat sink not to be level:
– The CPU is not positioned correctly.
– The wire clip is not engaged correctly.
„
Do not move the secured heat sink.
10.
Install the components you removed previously.
11.
Power on the server.
12.
Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and reboot the
system.
After rebooting the system, the NEC EXPRESSBUILDER menu appears on the screen.
13.
Click [End], and select [DOS].
14.
Enter as "cd SDR" against the prompt "Q:\>" and press Enter .
15.
Enter as "SDRUP" against the prompt "Q:\SDR>" and press
Enter
.
16.
Updating the configuration data is started.
If the following message is displayed on the way, press
Enter
to continue updating.
Password (Q to quit):
It takes about five to six minutes to complete updating.