CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
Preliminary User’s Manual U19014EJ1V0UD
174
6.6 Cautions for 16-Bit Timer/Event Counter 00
(1) Restrictions for each channel of 16-bit timer/event counter 00
Table 6-3 shows the restrictions for each channel.
Table 6-3. Restrictions for Each Channel of 16-Bit Timer/Event Counter 00
Operation Restriction
As interval timer
As square wave output
−
As external event counter
TOC00 = 00H
As clear & start mode entered by
TI000 pin valid edge input
Using timer output (TO00) is prohibited when detection of the valid edge of the TI010 pin is
used.
TOC00 = 00H
As free-running timer
−
As PPG output
Setting identical values or 0000H to CR000 and CP010 is prohibited.
As one-shot pulse output
−
As pulse width measurement
TOC00 = 00H
(2) Timer start errors
An error of up to one clock may occur in the time required for a match signal to be generated after timer start.
This is because counting TM00 is started asynchronously to the count pulse.
Figure 6-55. Start Timing of TM00 Count
0000H
Timer start
0001H
0002H
0003H
0004H
Count pulse
TM00 count value
(3) Setting of CR000 and CR010 (clear & start mode entered upon a match between TM00 and CR000)
Set a value other than 0000H to CR000 and CR010 (TM00 cannot count one pulse when it is used as an external
event counter).
electronic components distributor
