CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00
Preliminary User’s Manual U19014EJ1V0UD
165
(1) Measuring the pulse width by using two input signals of the TI000 and TI010 pins (free-running timer
mode)
Set the free-running timer mode (TMC003 and TMC002 = 01). When the valid edge of the TI000 pin is detected,
the count value of TM00 is captured to CR010. When the valid edge of the TI010 pin is detected, the count value
of TM00 is captured to CR000. Specify detection of both the edges of the TI000 and TI010 pins.
By this measurement method, the previous count value is subtracted from the count value captured by the edge
of each input signal. Therefore, save the previously captured value to a separate register in advance.
If an overflow occurs, the value becomes negative if the previously captured value is simply subtracted from the
current captured value and, therefore, a borrow occurs (bit 0 (CY) of the program status word (PSW) is set to 1).
If this happens, ignore CY and take the calculated value as the pulse width. In addition, clear bit 0 (OVF00) of
16-bit timer mode control register 00 (TMC00) to 0.
Figure 6-48. Timing Example of Pulse Width Measurement (1)
•
TMC00 = 04H, PRM00 = F0H, CRC00 = 05H
FFFFH
TM00 register
0000H
Operable bits
(TMC003, TMC002)
Capture trigger input
(TI000)
Capture register
(CR010)
Capture interrupt
(INTTM010)
Capture trigger input
(TI010)
Capture register
(CR000)
Capture interrupt
(INTTM000)
Overflow flag
(OVF00)
01
M
A
B
C
D
E
N
S
P
Q
00
0 write clear
0 write clear
0 write clear
0 write clear
0000H
A
B
C
D
E
0000H
M
N
S
P
Q
electronic components distributor
