NEC Express5800/T120a-E N8100-1531F, User Manual, Page: 205 / 542

Installing the Operating System with Express Setup 5-27
8.
Click [TEAM: "Team name"] from [Device manager]
→
[Network adapters] to modify
the team.
Click [Settings] tab and click [Modify Team] button.
9.
Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Point the adapter and click [Set Primary] button.
– Set Secondary
Point the adapter and click [Set Secondary] button.
NOTE: Adapter priority config can be confirmed by the following
procedure:
1. Click [TEAM: "Team name"] from [Device manager]
→
[Network
adapters].
2. Click [Settings] and confirm Adapters in team list.
10.
Click [Test Switch]
→
[Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results]
Even if the system is normal, the following mismatch message will appear sometimes.
Recheck the switching hub (L2) port and if there is no problem with the setting, ignore the
messages.
– The switch is configured with aggregated ports, but the team type does not support port
aggregation. The switch is configured with VLAN tagging, but the team has no
VLANs.
– Change the team type to SLA, reconfigure the switch for link aggregation, or disable
VLAN tagging on the switch.
11.
Restart the system.
Remove Team
1.
Open the [Device Manager].
2.
Click [Network adapters], and open [TEAM: "Team name"] properties.
3.
Click [Setting] tab.
4.
Click [Remove Team] button.
5.
Click [Yes] to the message.
6.
Confirm [TEAM: "Team name"] adapter is not existing in [Network adapters] tree and
restart the system.