Nautel VX150, Operation & Maintenance Manual

Page: 118 / 179

VX150 TO VX2 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 1.0 2022-12-08 PAGE 2.2.101
Network Setup - Using the Front Panel
From the transmitter’s front panel, in local mode, you can set or change network settings. Select
Network from the main menu. See
Figure 2.2.72 for values provided by the DHCP server (values shown
are examples only).
Use the Front Panel rotary knob to move the cursor to the desired parameter and then press to enable
editing of the setting. Within any of the editing screens, use the Front Panel rotary knob to edit. Press
the Back button to discard changes and return to the previous menu.
If you are using a laptop to connect to the VX150 to VX2, see Connecting a Laptop Directly to the
Transmitter on page 2.2.101 .
Figure 2.2.72: Network Screen (DHCP On)
Connecting a Laptop Directly to the Transmitter
If connecting to the VX150 to VX2 directly with a laptop, you must set a static IP address on the VX150
to VX2 and your laptop.
1. From the Front Panel UI, go to Network and set the IP address as follows:
• DHCP: OFF
• IP Address: 10.10.10.2
• Netmask: 255.255.255.0
2. Set the transmitter for Remote control.
NOTE
: The following steps assume the operating system is Windows 10 or newer. Adapt as required for
computers with different operating systems.
3. On the laptop, go to Start Menu/Control Panel/Network Connections/Local Area Network.