Muratec F-525, Field Engineering Manual

Page: 269 / 383

4-3
4.4 Document Feeder Multi-feeding or Skew
Symptom: Two or more pages of a multi-page document are fed at once.
The document is fed on the skew. Slight skewing may sometimes occur.
Suggested corrective action:
1. Verify that the original documents conform to the specifications designed for use in the machine
and they are not damaged in any way.
2. Verify the pages of the document are not stuck together from glue, wet or damp correction fluid,
tape, etc.
3. Verify the feed roller, separator roller and separator pad are clean and not damaged. Clean using
a lint-free cotton cloth moistened with a cleaning solution designed for on rubber rollers. Replace
these items if worn or damaged.
4.5 Mirror Carriage Error (MFX-2050/MFX-1450 only)
Symptom: The mirror carriage doesn’t move.
Suggested corrective action:
1. Verify that the scanner unit locking switch has been released. Release the scanner unit locking
switch if it is not released. Then press <Setting>, <*>, <1>, <4> to turn off the mirror carriage carry
mode.
2. Verify that the timing belt doesn’t out of joint.
3. Check the operation of HOME sensor at connector P2, pin 1-3, on the CCD PCB.
4.6 Clearing Jammed Paper
4.6.1 If the original document jams
1. If an original document jams in the ADF while scanning the document into the memory for faxing or
copying, the LCD will show:
If you do wish to continue the operation, press [Yes] and proceed to step 2.
To abort the operation, press [No
] . This will erase from memory all pages stored during this opera-
tion, and the machine will return to standby mode.
Important: If you wait more than 60 seconds without pressing any key, the machine will erase from
memory all pages stored during this operation and the machine will return to the standby
mode.
Note: If the document jammed in the following case, the following message will appear and the
machine will abort the operation anyway; instead, you’ll have to perform the job again from
scratch.
• The first page of the document jammed
• During the real time transmission or quick memory transmission
• During non-sorting ADF job