Muratec F-525, Field Engineering Manual

Page: 141 / 383

3-57
Memory Switch 012 — Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 0 Factory use only
6 0 Factory use only
5 0 Changing the date format of
the transmitted TTI
0: No
1: Yes
When set to “1”, the machine changes the date
format of the transmitted TTI from MM:DD:YY, or
vice versa.
4 1 TTI transmit
0: No
1: Yes
(Note: Turning TTI
transmission off may violate
local or federal regulations.)
When set at “0”, transmission of the TTI is disabled.
The TTI includes the followings:
•
Sender name
•
Sender’s fax number
•
Data & time, and number of pages
To set the individually transmission of them, see
Memory SW 016.
3 0 ECM response time
0: 3 sec
1: 4.8 sec
The time limit to receive the response signal for the
ECM post message.
2 0 ECM error retransmit time
0: 200 ms
1: 400 ms
The time limit before the ECM error is retransmitted.
1 0 Interval between DIS and DCS
0 0 0 ms 500 ms 1000 ms 1500 ms
Switch 1 0 0 1 1
Switch 0 0 1 0 1
Memory Switch 013 — Transmission
Switch
Initial
Setting
Adjust Usage/Comments
7 0 ANSam detection
0: Yes
1: No
During the V8 handshake, if some noise disturbs
the handshake and an error occurs, set to “1”.
6 0 V.34 transmission
0: Yes
1: No
Individual setting for V.34 transmission.
5 0 CSI/TSI/CIG transmit
0: Yes
1: No
When set at “1”, transmission of the CSI, TSI and
CIG signals are disabled.
4 0 ECM mode
0: On
1: Off
Determines ECM mode. ECM mode reduces
document memory and may lengthen transmission
and reception times.
3 0 Retransmit automatically
when receiving RTN/PIN
signals
0: Yes
1: No
When set to “1”, retransmission disables
automatically if receiving RTN/PIN signals.
2 1 Factory use only
1 0 Factory use only
0 0 Factory use only
 

 

 
 
 
 
 
 
 
 