Muratec F-525, Field Engineering Manual

Page: 193 / 383

3-109
7. If you’ve replaced the transfer roller, select [Replace Fuser].
The LCD shows:
8. Press [Yes] . The machine goes back to standby mode.

When “Call Service : XX” message is displayed on the LCD
To access the printer maintenance modes for determine the cause of the “Call Service : XX” error
message.
1. Press <Setting>, <*>, <0>, <6>.
2. Press [Service Call].
3. The kind of printer error will be displayed. If happens two or more troubles, the number of troubles
is displayed on the right upper of the LCD. For example, when “Heater error” and “Drum Fuse
Error” has occurred, the LCD shows 2.
4. Press [Enter] to show the other printer error.
5. Press <Reset> to exit this mode.
Note: See “4.11.1 Call Service : XX” page 4-17 to 4-19 for the printer error messages and an expla-
nation of each are outlined.

Register the e-mail location
To send the service error via e-mail, register the location using this mode.
1. Press <Setting>, <*>, <0>, <6>.
2. Press [Service Call E-mail].
3. Select [Send Call E-Mail].
2 Number of troubles 2 Number of troubles