Motorola Netopia 7000, Administrator'S Handbook

Page: 279 / 368

279
set pinhole name name protocol-select { tcp | udp }
Specifies the type of protocol being redirected.
set pinhole name name external-port-start [ 0 - 49151 ]
Specifies the first por t number in the range being translated.
set pinhole name
name
external-port-end [ 0 - 49151 ]
Specifies the last por t number in the range being translated.
set pinhole name name internal-ip internal-ip
Specifies the IP address of the internal host to which traffic of the specified type should be transferred.
set pinhole name name internal-port [ 0 - 65535 ]
Specifies the por t number your Motorola Netopia® Gateway should use when for warding traffic of the spec-
ified type. Under most circumstances, you would use the same number for the external and internal por t.
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, por t authentication settings, and peer
authentication settings for PPP inter faces on your Motorola Netopia® Gateway.
Configuring Basic PPP Settings.
☛
NOTE:
For the DSL platform you must identify the vir tual PPP inter face [
vccn
], a number from 1 to 8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Motorola Netopia® Gateway.
set ppp module [vccn] auto-connect { on | off }
Suppor ts manual mode required for some vendors. The default
on
is not normally changed. If auto-connect
is disabled (
off
), you must manually star t/stop a ppp connection.
set ppp module [vccn] mru
integer
Specifies the Maximum Receive Unit (MRU) for the PPP inter face. The integer argument can be any num-
ber between 128 and 1492 for PPPoE; 1500 other wise.