![Motorola Netopia 7000 Administrator'S Handbook Download Page 242](http://html.mh-extra.com/html/motorola/netopia-7000/netopia-7000_administrators-handbook_243781242.webp)
Administrator’s Handbook
242
Displaying Current Gateway Settings
You can use the
view
command to display the current CONFIG settings for your Motorola Netopia® Gate-
way. If you enter the
view
command at the top level of the CONFIG hierarchy, the CLI displays the settings
for all enabled functions. If you enter the
view
command at an intermediate node, you see settings for that
node and its subnodes.
Step Mode: A CLI Configuration Technique
The Motorola Netopia® Gateway command line inter face includes a step mode to automate the process of
entering configuration settings. When you use the CONFIG step mode, the command line inter face prompts
you for all required and optional information. You can then enter the configuration values appropriate for
your site without having to enter complete CLI commands.
When you are in step mode, the command line inter face prompts you to enter required and optional set-
tings. If a setting has a default value or a current setting, the command line inter face displays the default
value for the command in parentheses. If a command has a limited number of acceptable values, those val-
ues are presented in brackets, with each value separated by a ver tical line. For example, the following CLI
step command indicates that the default value is
off
and that valid entries are limited to
on
and
off
.
option (off) [on | off]:
on
You can accept the default value for a field by pressing the Return key. To use a different value, enter it and
press Return.
You can enter the CONFIG step mode by entering
set
from the top node of the CONFIG hierarchy. You can
enter step mode for a par ticular ser vice by entering
set
service_name
.
In stepping set mode (press
Control-X <Return/Enter> to exit. For example:
Netopia-3000/9437188 (top)>>
set system
...
system
name (“Netopia-3000/9437188”):
Mycroft
Diagnostic Level (High):
medium
Stepping mode ended.
Validating Your Configuration
You can use the
validate
CONFIG command to make sure that your configuration settings have been
entered correctly. If you use the
validate
command, the Motorola Netopia® Gateway verifies that all
required settings for all ser vices are present and that settings are consistent.
Netopia-3000/9437188 (top)>>
validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the
validate
command to verify your configuration settings at any time. Your Motorola Neto-
pia® Gateway automatically validates your configuration any time you save a modified configuration.
Summary of Contents for Netopia 7000
