Administrator’s Handbook
178
Example:
You want packets with the TOS low latency bit to go
through VC 2 (via gateway 127.0.0.3 – the Motorola Netopia®
Gateway will use 127.0.0.
x
, where
x
is the WAN por t + 1) instead
of your normal gateway.
You would set up the filter as shown here.
☛
NOTE:
Default Forwarding Filter
If you create one or more filters that have a matching action of
for ward
, then action on a
packet matching
none
of the filters is to block any traffic.
Therefore, if the behavior you want is to force the routing of a cer tain type of packet and pass
all others through the normal routing mechanism, you must configure one filter to match the
first type of packet and apply Force Routing. A subsequent filter is required to match and for-
ward all other packets.
Management IP traffic
If the Force Routing filter is applied to source IP addresses, it may inadver tently block commu-
nication with the router itself. You can avoid this by preceding the Force Routing filter with a fil-
ter that matches the destination IP address of the Gateway itself.
Summary of Contents for Netopia 7000
