Mitsubishi Electric Q80BD-J61BT11N, User Manual

Page: 207 / 362

13 - 7 13 - 7
MELSEC
13 COMMUNICATION BETWEEN THE MASTER STATION AND
INTELLIGENT DEVICE STATION (AJ65BT-R2)
13.4.2 Data transmission
The following illustrates the relation between the intelligent device station’s I/O
operations and the user program on the PC and their data transmission. (The shaded
areas indicate the devices that are actually used.)
mdSend
Buffer memory
RX0
RX1
:
CC-Link Ver.2 board
RX0 (transmission normal complete)
Intelligent device station (station No. 1)
Master station (station No. 0)
Personal computer
User program
mdReceive
:
RY0
Remote inputs (RX)
Remote outputs (RY)
: :
RY0 (transmission request)
mdSend
200H
201H
to
3FFH
1)
2)
3)
4)
5)
5) 4)
6)
7)
8)
RX1 (transmission error complete)
(transmission data size designation area)
(transmission data designation area)
1: When the remote net Ver.2 mode is selected, refer to the figure in Section 4.4.7(1).
When the remote net additional mode is selected, refer to the figure in Section 4.4.7(2).
User Program CC-Link Ver.2 Board
1) Writes the send data to the transmission area
of the AJ65BT-R2 buffer memory.
2) Turn ON the transmission request signal (RY0). 3) Turn ON the transmission request signal (RY0) of the
AJ65BT-R2.
4) The AJ65BT-R2 sends data to external equipment, and
if the transmission is normal, it turns ON the
transmission normal complete signal (RX0).
If an error is identified in the transmission, the AJ65BT-
R2 turns ON the transmission error complete signal
(RX1).
5) Reads out the transmission normal complete
signal (RX0) and the transmission error
complete signal (RX1).
6) Turns OFF the transmission request signal
(RY0).
7) Turns OFF the transmission request signal (RY0) of the
AJ65BT-R2.
8) The AJ65BT-R2 turns OFF the transmission normal
complete signal (RX0) or transmission error complete
signal (RX1).