Mitsubishi Electric Q80BD-J61BT11N, User Manual

Page: 129 / 362

6 - 5 6 - 5
MELSEC
6 PARAMETER SETTINGS
6.2 Parameter Setting Examples (Remote Net Ver.1 Mode)
This section explains the parameter settings using the CC-Link Ver.2 utility.
6.2.1 Master station network parameter settings
The descriptions in this section are based on the following system configuration
example.
For details of the CC-Link Ver.2 utility, refer to Section 8.2.
Master station
Q80BD-
J61BT11N
Remote I/O
station
(occupies
1 station)
Local station
QJ61BT11
(occupies
4 stations)
Station
number 1
Ver.1 compatible
remote device
station
(occupies
2 stations)
Station
number 3
Station
number 4
Station
number 8
Remote I/O
station
(occupies
1 station)
Setting item Setting value
Sta. No. 0
Type Master station
Transmission rate 10 Mbps
Mode Remote net [Ver.1 mode]
Operational
settings
Expanded cyclic single
Occupied Sta. Occupies 1 station
Input for Err. Sta. Clear
Other
settings
Retry count 3 (Times)
Automatic reconnection station count 1 (Module)
Standby master station No. 0 (no standby master station designated)
Delay information setting 0 50 micro sec
Driver WDT Monitoring Time 250 8 ms
Block data assurance per station Disable
Link refresh cycle ----
Station information
settings
All connect count 4 (Modules)
Station information Refer to the Table below.
Station information setting items
Setting item Setting value
No. / Sta. No. 1/1 2/3 3/4 4/8
Station type
Remote device
station
Remote I/O station
Intelligent device
station
Remote I/O station
Expanded cyclic single single single single
Occupied Sta. Occupies 2 stations Occupies 1 station Occupies 4 stations Occupies 1 station
Remote station points 64 points 32 points 128 points 32 points
Reserve/invalid station select No setting No setting No setting No setting
Intelligent buffer
select (word)
Send ---- ---- 16 ----
Receive ---- ---- ---- ----
Automatic ---- ---- ---- ----
: Setting not required