Mitsubishi Electric Q80BD-J61BT11N, User Manual

Page: 188 / 362

12 - 4 12 - 4
MELSEC
12 COMMUNICATION BETWEEN THE MASTER STATION AND LOCAL
STATIONS
12.1.3 Setting the local station
The following shows the local station setting.
(1) Switch setting (channel No. setting)
The channel No. for the CC-Link Ver.2 board is set to 81 as an example in this
section.
For the setting, refer to Section 12.1.2 (1).
(2) Parameter settings
The following shows the local station’s parameter settings by the CC-Link Ver.2
Utility.
<Parameter settings screen> <Other settings screen>
1)
3)
4)
7)
6)
5)
2)
8)
9)
10)
(a) Parameter settings
The following shows the parameter setting values. The parameter setting
check list and the station information setting check list in Appendix can be
used for the setting.
Table 12.3 Parameter Setting Check List
Setting item Setting range/Item
1) Channel No.
Channel No. 81 / Channel No.82
Channel No. 83 / Channel No.84
2) Sta. No./Type No.1 Master station / Local station / Standby master station
3) Transmission rate 156kbps / 625kbps / 2.5Mbps / 5Mbps / 10Mbps
4) Mode
Remote net [Ver.1 mode] / Remote net [Ver.2 mode]
Remote net [Additional mode] / Off line
Operational
settings
5) Expanded cyclic single / double / quadruple / octuple
6) Occupied Sta.
Occupies 1 station / Occupies 2 stations
Occupies 3 stations / Occupies 4 stations
7) Input for Err. Sta. Hold / Clear
Other settings
Retry count 3 Times
Automatic reconnection
station count
1 Modules
Standby master station No.
No.0
Delay information setting
0 50 micro sec
8) Driver WDT Monitoring Time No setting / 8 ms
9) Block data assurance per
station
Disable / Enable
10) Link refresh cycle No setting / ms
Station information
settings
All connect count Modules